This como resetar samsung pocket neo command is available when using the BRI qsig or PRI qsig switch type in either master or slave mode.
If one of the checks fails, it indicates the background process is not started, and instead you see an error response to the command.
Examples The following example configures the interface (configured for Net5) to emulate the network-side isdn: Router(config int s0:15 Router(config-if isdn protocol-emulate network The following example configures the layer 2 and layer 3 function of T1 PRI interface 23 to act as the qsig master (NT.Isdn bind-l3 iua-backhaul application - server - name no isdn bind-l3 iua-backhaul Syntax Description application - server - name (Optional) Name of the application server (AS) to use for backhauling the interface.Show iua asp Shows information about the current condition of an ASP.81 Invalid call reference value.This script sets certain environment variables that are necessary for httpd to function correctly under some operating systems, and then invokes the httpd binary.To restore the user-side notification, use the no form of this command.Command Default No default behavior or values Command Modes Interface configuration Command History Release Modification.1(2)T This command was introduced on the following platforms: Cisco 2600 series, Cisco 3600 series, Cisco 7200 series, and Cisco MC3810.12.2(8)T This command was implemented on the Cisco IAD2420 series.Examples The following example configures T1 signaling channel serial 0:23 for signaling backhaul and associate the D channel with the session set named "Set1 Router(config interface s0:23 Router(config-if isdn bind-L3 set1 Router(config-if exit The following example configures E1 signaling channel serial 0:15 for signaling backhaul.In some cases, the command will automatically be configured after the BRI network-side protocol emulation is set.Usage Guidelines Use this command to specify contiguous bearer channel handling so that B channels 1 to 30, skipping 16, map to time slots 1.Protocol emulation must be set to user, which is the default for the isdn protocol-emulate command.Perform the following checks before initiating the background process.Isdn switch-type (PRI) Specifies the central office switch type on the isdn interface.On Windows, Apache is normally run as a service on Windows NT, 2000 and XP, or as a console application on Windows 9x and.
The ixi transport command enters XML transport configuration mode where you can set transport configuration parameters.12.2 The preserve and remove keywords were added.Usage Guidelines The isdn outoing display-ie command is direction dependent, such as network-to-user or user-to-network.Command Default No default behavior or values Command Modes Global configuration Command History Release Modification.2(4)T This command was introduced.Usage Guidelines You must first enter IUA configuration mode to access sctp configuration mode.This command is not supported from a BRI interface.To disable the displaying texas holdem hands odds chart of the information element in the outgoing isdn message, use the no form of this command.50 Requested facility not subscribed.86 Call with requested call ID is cleared.It also binds isdn Q931 Layer 3 to the Cisco CallManager.Use this command to download audio files from tftp to memory.This keyword is supported only for user-side isdn interfaces.Isdn contiguous - bchan no isdn contiguous - bchan Syntax Description This command has no arguments or keywords.Usage Guidelines Use this command to limit the maximum memory allowed for audio recordings during a single call session on a VoiceXML-enabled gateway.
This command allows the original cause code to be changed to the value specified if the original cause code is not one of the following: normal_clearing (16) user_busy (17) NO_user_responding (18) NO_user_answer (19) number_changed (22) invalid_number_format (28) unspecified_cause (31) unassigned_number (1) Table 29 describes the cause.